Page 42 194412(11) - Hill-Rom® 900 Accella™ Bed - Instructions For Use
Alert suspension mode
When a detection function is activated, it can be suspended using the
Suspend Alert for
30 sec
command on the home screen, then suspended again for 5 to 10 minutes, without
having to deactivate the detection function.
To activate the alert suspension mode
Select
Suspend Alert for 30 sec
on the touch
screen.
The patient can now move and follow procedures
wi
thout any alerts sounding.
Selecting alert suspension mode
A screen opens where you can select:
Resume
,
Suspend 5 min
or
Suspend 10 min
and
Disarm
. If nothing is selected on this screen, the
systems waits for 30 seconds, then attempts to activate itself in the previously activated
detection mode.
This operation is performed when a patient is present on the bed.
If the head section is not raised to the required angle, an alert sounds.
If the bed does not detect a patient, it s
witches to “Awaiting patient” mode.
• Suspend 5 min or Suspend 10 min
: if the
duration of the suspension is too short,
suspend for a further 5 to 10 minutes
before the bed attempts to switch the
detection function on again. If the bed
does not detect a patient, it switches to
“Awaiting patient” mode. If the head
section is not raised to the required angle,
an alert sounds. Maintenance staff can
adjust the 5 or 10 minute settings
(see
“Setting the length of the alert suspension
mode” page 53).
• Resume: switches
the detection back on immediately.
• Disarm: switches the detection off.
You can change the volume of the alert by replacing the default value with a
higher or a lower volume (three levels available) (see “Setting the alerts volume”
page 53).
To Next Page
Loading...
Need help?
General
