Page 48 194412(11) - Hill-Rom® 900 Accella™ Bed - Instructions For Use
combined Accella™ Therapy mattress*
The Accella™ Therapy is a therapeutic mattress. It has two operating modes: continuous
low pressure (CLP) and alternating low pressure (ALP), with permanent regulation by the
I-mmersion™ sensor in both modes.
This device is intended for patients weighing between 40 and 185-215 kg,
depending on the environment, and offers therapeutic benefits up to 160 kg.
This paragraph describes the installation and use of the Hill- Rom® 900 Accella™
combined mattress using the GCI™ interface. For additional and specific information
about the mattress, refer to the mattress Instructions for Use.
Description of the mattress screen (default mode)
Stop mattress
Mattress
status
Activate
P-max mode
Deflate mattress
Activate /
Deactivate
MCM™* mode
Activate
ALP mode
Activate
CLP mode
Installing the mattress
1. Disconnect the bed power cord from the wall outlet.
2. Take the mattress out of its original packaging or transport bag and place it at
the head of
the bed.
3. Undo the retaining strap and unroll the mattress.
4. Fold in two on the head side.
5. Remove the hard surface of the thigh section.
6. Install the cable as shown on the label.
To Next Page
Loading...
Need help?
General
