194412(11) - Hill-Rom® 900 Accella™ Bed - Instructions For Use Page 55
Mobilizing the patient
Failure Codes
If there is a fault with a function of the bed or mattress* a failure code is generated. A list
of these codes and the history is available on the GCI screen.
When a fault occurs, the associated failure code appears on the screen.
To view the list of codes:
1. Press Parameters on the GCI.
2. Press Failure Codes.
3. Wait for the codes to appear, then press the Close button.
4. The list of codes and the history appear on the
GCI scr
een.
If the fault is with an Accella™ Therapy mattress, there
is a button to pause the alert for 10 minutes on the
failure codes screen.
A list of codes, their descriptions and associated
solutions can be found in the service manual of the
bed or mattress. 1XXX codes relate to the mattress.
Wi-Fi connection
When the bed is connected and located, it sends the data by Wi-Fi.
List of information that can be sent by Wi-Fi
The information retrieved depends on the hospital’s communications system.
This list is subject to change according to the version of the bed.
•Bed identification • Patient weight, with the date and time
• Brake bar position: brake applied / not
appl
ied
•Error codes
• Bed in low position indicator • Angle of the sleep surface
b
• Half-siderail locked / unlocked • Function lockout status
b
• Patient's presence in the bed
ab
a. by SmartSync™.
b. by Hillrom™ Digital Health Gateway.
•CPR
b
status
•Head section angle • Scales reset notification
b
• Adjustable head section angle alert • Last scales function used
b
•Bed exit alerts • Bed battery charge level
b
To Next Page
Loading...
Need help?
General
