Page 56 194412(11) - Hill-Rom® 900 Accella™ Bed - Instructions For Use
With a combined mattress
• Mattress battery charge level
a
a. by Hillrom™ Digital Health Gateway
• P-Max mode status
a
• ON/OFF mode
a
• Deflate mode status
a
• Current therapeutic mode
a
• Mattress error codes
a
• MCM mode status
a
Hill-Rom cannot guarantee the information sent over Wi-Fi. Medical decisions must be
made on the basis of the information and alerts shown on the bed by the built-in
equipment.
If the bed is moved out of the room (battery mode), the Wi-Fi is deactivated and the bed
does not send any more information to the facility’s communications system.
Meaning of the Wi-Fi connection information on the GCI
Wi-Fi OFF
Wi-Fi ON with a weak Wi-Fi signal
Wi-Fi ON with an intermediate Wi-Fi signal
Wi-Fi ON with a strong Wi-Fi signal
Bed located
Bed located and patient identified
If the bed switches to battery mode, it is no longer assigned, but remains paired for
3 minutes (SmartCare™) or 1 minute (
Hillrom™ Digital Health Gateway). After this
time, it is necessary to proceed with a new assignment.
The bed is located manually with the Hillrom™ Digital Health Gateway.
If the Wi-Fi function was not activated on first use of the bed, connection may not
be possible. In this case, contact the supplier of the communications system to
solve the problem.
To Next Page
Loading...
Need help?
General
