Page 78 194412(11) - Hill-Rom® 900 Accella™ Bed - Instructions For Use
The following recommendations are designed to prevent any possible incidents so
that this accessory can be used in optimum safety conditions for both the patient
and nursing staff.
• Check that the cylinder is correctly
positioned at the base of the cylinder
holder.
• Never use a different oxygen cylinder
model from the model that is specified
above (danger of dropping the cylinder
or interfering with various operations
could occur).
• Prevent any impact when moving a bed
e
quipped with a cylinder holder
(especially doorways).
• If the cylinder holder does not allow the
b
ed to go through a doorway, position
the holder in front of the bed, otherwise
place it and the cylinder on the mattress
(remember to put the holder in its normal position after moving the bed).
Pivoting 3L Bottle Holder (AC962A)**
The bottle holder is designed to accept a 3 litter bottle and
can be fitted on the supports at the foot end of the bed
outside the sleep surface. It can be rotated through 80°.
The following recommendations are
designed to prevent any possible
incidents so that this accessory can be
used in optimum safety conditions for
both the patient and nursing staff.
• Prevent any impact when moving a bed
equipped with a bottle holder
(especially doorway or reverse
Trendelenburg).
• If the bottle holder does not allow the
bed to go through a doorway, position
the holder in front of the bed,
(remember to put the holder in its
normal position after moving the bed).
To Next Page
Loading...
Need help?
General
