194412(11) - Hill-Rom® 900 Accella™ Bed - Instructions For Use Page 49
Mobilizing the patient
7. Connect the plug to the bed connector (it clicks into place).
8. Install the hard surface of the thigh section.
9. Attach the mattress to the middle section of the frame with the straps.
10. Adjust the length of the straps.
11. Unfold the mattress.
12. Fold back the folding mattress clamp (see “Folding mattress clamp” page 22)
13. Open the cover at the head end and check that the deflation plug is screwed
tigh
t.
14. Connect the power cord to the wall outlet.
Make sure that the device is correctly installed and attached, well centered on the
sleep surface and securely fixed to the board at the foot end to avoid the formation
of entrapment zones and check the space at the head of the bed
(see “Headboard”
page 45).
Activating the mattress
1. Make sure that the mattress is properly installed (see “Installing the mattress”
page 48).
2.
Press Mattress on the CGI.
3. Press Start.
4. The mattress switches to initialization mode
. A beep
sounds after 20 minutes, indicating that the mattress is
operational.
5. The status of the mattress switches to ON in the default mode.The ALP and
MCM a
re active.
To Next Page
Loading...
Need help?
General
