EasyManuals Logo

Hillrom Accella 900 User Manual

Hillrom Accella 900
114 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #58 background imageLoading...
Page #58 background image
Page 52 194412(11) - Hill-Rom® 900 Accella™ Bed - Instructions For Use
Stopping the mattress
To stop the mattress:
1. Press Mattress du GCI.
2. Press Stop.
3. The mattress deflates in about 1 minute.
4. A sound signal indicates that the mattress
can be disconnected.
5. Confirm that the mattress has been stopped.
NOTE:
If the mattress is disconnected without properly following the procedure to stop the
mattress, it switches to fault mode.
Disconnecting and storing the mattress
1. Make sure that the mattress has been stopped properly (see “Stopping the
mattress” page 52).
2. Disconnect the bed power cord from the wall outlet.
3. Open the head end zip fastener. Unscrew the deflation plug.
4. Undo the straps attaching the mattress to the bed frame.
5. Fold in two at the head end.
6. Remove the hard surface of the thigh section.
7. Disconnect the plug from the bed connector.
8. Remove the cable.
9. Install the hard surface of the thigh section.
10. Unfold the mattress.
11. Starting at the foot end of the bed, roll up the mattress slowly to allow any
r
emaining air to be expelled.
12. Close the deflation plug and close the zip fastener.
13. Put the retaining strap back in place.
14. Place the rolled up mattress in a plastic bag.
15. Store the mattress in its original packaging or in a transport bag.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hillrom Accella 900 and is the answer not in the manual?

Hillrom Accella 900 Specifications

General IconGeneral
BrandHillrom
ModelAccella 900
CategoryMedical Equipment
LanguageEnglish

Related product manuals