Page 92 194412(11) - Hill-Rom® 900 Accella™ Bed - Instructions For Use
Steam Cleaning
These beds can be steam cleaned. However, in order to avoid any damage or
deterioration caused by high pressure or abnormal surface temperature, the
following precautions should be taken:
• avoid any excess water and use reduced steam pressure with microfiber
support when cleaning electrical components (control unit, actuators, lateral
caregiver units, half-siderails with keypads, remote controls and control
cluster arms),
• do not use accessories such as high pressure hoses (A). It is preferable to
use soft non-metallic brushes (B) and microfiber support (C) in such a way as
to reduce the pressure to an acceptable level,
Clean with a microfiber support only.
Clean with a soft non-metallic brush or a microfiber support.
Steam cleaning areas
• prevent water and steam from getting into connectors that are not in use,
• do not brush and use reduced pressure on labels and markings,
• carefully dry and test the bed before reuse.
To Next Page
Loading...
Need help?
General
