Hills DAS ComNav - Bypassing Zones

23
Hills – ComNav User Manual V1.3 www.das.com.au
Menu 2 - System Control
2.1
Security System Status
2.2
Area Control

2.3
To Control Zone Bypass
2.4
Event History
Bypassing
The zone bypass menu is used to bypass (isolate) selected zones in your security system. A
bypassed zone is not capable of activating an alarm, as it is temporarily removed from your
system. Bypassing zones lowers your level of security and caution should be exercised. All
bypassed zones are reset and cleared from memory when your security system is next armed /
disarmed. Your security system must be disarmed (turned off) before being able to bypass zones.
After bypassing your selected zones, your security system must be armed (turned On) in either the
away or stay mode to secure the remaining zones
How to: Bypass zones within your security system
Step Example: Away Arm, Stay Arm or Disarm areas within a Multi area system
1.
[PIN]
Call the ComNav via an offsite touch-tone phone to begin the session.
2.
Press [2] for system control menu
Press [3] to control zone bypass
3. To control zone bypass, select a zone number followed by #
4.
Press 0, to bypass / Un-bypass
(Toggles zone from un-bypassed to bypassed Or if already bypassed,
from bypassed to un-bypassed)
5.
1
st
star, moves back to system control menu
2
nd
star, moves back to main menu.
3
rd
star, disconnects session