3 Product Description F3 AIO 8/4 01
Page 18 of 54 HI 800 161 E Rev. 1.01
3.3 Equipment, Scope of Delivery
The following list specifies the available components and the corresponding part numbers:
Designation Description Part no.
F3 AIO 8/4 01
Remote I/O with 8 analog inputs and 4 non-safety-
related analog outputs,
Operating temperature 0…+60 °C, for ELOP II
Factory programming tool
98 2200409
F3 AIO 8/4 011
(-20 °C)
Remote I/O with 8 analog inputs and 4 non-safety-
related analog outputs,
Operating temperature -20…+60 °C, for ELOP II
Factory programming tool
98 2200457
F3 AIO 8/4 012
(subsea / -20 °C)
Remote I/O with 8 analog inputs and 4 non-safety-
related analog outputs,
Operating temperature -20…+60 °C, subsea,
Complying with ISO 13628-6: 2006, for ELOP II
Factory programming tool
98 2200458
F3 AIO 8/4 01
SILworX
Remote I/O with 8 analog inputs and 4 non-safety-
related analog outputs,
Operating temperature 0…+60 °C, for SILworX
programming tool
98 2200483
F3 AIO 8/4 011
SILworX
(-20 °C)
Remote I/O with 8 analog inputs and 4 non-safety-
related analog outputs,
Operating temperature -20…+60 °C, for SILworX
programming tool
98 2200489
F3 AIO 8/4 012
SILworX
(subsea / -20 °C)
Remote I/O with 8 analog inputs and 4 non-safety-
related analog outputs,
Operating temperature -20…+60 °C, subsea,
Complying with ISO 13628-6: 2006, for SILworX
programming tool
98 2200493
Table 10: Part Numbers
3.3.1 IP Address and System ID (SRS)
A transparent label is delivered with the device to allow one to note the IP address and the
system ID (SRS for system rack slot) after a change.
IP___.___.___.___SRS____.__.__
Default value for IP address: 192.168.0.99
Default value for SRS: 60000.200.0 (SILworX)
60000.0.0 (ELOP II Factory)
The label must be affixed such that the ventilation slots in the housing are not obstructed.
Refer to the First Steps manual of the programming tool for more information on how to
modify the IP address and the system ID.