HIMA HIMatrix F3 AIO 8/4 01 User Manual

3 Product Description F3 AIO 8/4 01
Page 24 of 54 HI 800 161 E Rev. 1.01
3.5.2 Communication
The remote I/O communicates with the associated controller via safeethernet.
3.5.2.1 Connections for Ethernet Communication
Property Description
Port 2 x RJ-45
Transfer standard 10/100/Base-T, half and full duplex
Auto negotiation Yes
Auto crossover Yes
Connection socket RJ-45
IP address Freely configurable
1)
Subnet mask Freely configurable
1)
Supported protocols
 Safety-related: safeethernet
 Non-safety-related:
programming and debugging tool (PADT), SNTP
1)
The general rules for assigning IP address and subnet masks must be adhered to.
Table 14: Ethernet Interfaces Properties
The two RJ-45 connectors with integrated LEDs are located on the bottom left-hand side of
the enclosure. Refer to Chapter
3.5.1.3 for a description of the LEDs' function.
The connection parameters are read based on the MAC address (media access control
address) defined during manufacturing.
The MAC address for the remote I/O is specified on a label located above the two RJ-45
connectors (1 and 2).
Figure 6: Sample MAC Address Label
The remote I/O is equipped with an integrated switch for safety-related Ethernet
communication (safeethernet). For further information on the integrated switch and
safeethernet, refer to Chapter Communication of the System Manual for Compact Systems
(HI 800 141 E).
3.5.2.2 Network Ports Used for Ethernet Communication
UDP ports Usage
8000 Programming and operation with the programing tool
8001 Configuration of the remote I/O using the PES (ELOP II Factory)
8004 Configuration of the remote I/O using the PES (SILworX)
6010 safeethernet
123
SNTP (time synchronization between PES and remote I/O, PES and
external devices)
Table 15: Network Ports in Use

HIMA HIMatrix F3 AIO 8/4 01 Specifications

General

Brand	HIMA
Model	HIMatrix F3 AIO 8/4 01
Category	Controller
Language	English