Hioki BT3562-01 - Page 130

8.6 Message Reference
126
Set and Query Comparator Judgments
Syntax
Command
:CALCulate:LIMit:BEEPer <OFF/HL/IN/BOTH1/BOTH2>
Query
:CALCulate:LIMit:BEEPer?
Response <OFF/ HL/ IN/ BOTH1/ BOTH2>
OFF............ No beeps sound.
HL .............. The beeper sounds upon Hi and Lo judgments.
IN ............... The beeper sounds upon IN judgments.
BOTH1 ....... The beeper sounds continuously upon IN judgments,
and repeatedly upon Hi and Lo judgments.
BOTH2 ....... The beeper sounds once (briefly) upon IN judgments,
and repeatedly upon Hi and Lo judgments.
Example
Command
:CALC:LIM:BEEP IN
Query
:CALC:LIM:BEEP?
Response
IN
Set and Query the Comparator Execution Mode Setting
(Resistance Measurement)
Syntax
Command
:CALCulate:LIMit:RESistance:MODE <HL/ REF>
Query
:CALCulate:LIMit:RESistance:MODE?
Response <HL/ REF>
HL .............. Decision by preset upper and lower thresholds.
REF............ Decision by a reference value and tolerance.
Example
Command
:CALC:LIM:RES:MODE REF
Query
:CALC:LIM:RES:MODE?
Response
REF
(Voltage Measurement)
Syntax
Command
:CALCulate:LIMit:VOLTage:MODE <HL/ REF>
Query
:CALCulate:LIMit:VOLTage:MODE?
Response <HL/ REF>
HL .............. Decision by preset upper and lower thresholds.
REF............ Decision by a reference value and tolerance.