8.5 Message List
112
Device-Specific Commands
Message ([ ] = optional) Data Contents
( ) = response data
Description Ref
page
Event Registers
:ESE0
0 to 255 Sets Event Status Enable Register 0 122
:ESE0?
0 to 255 Queries Event Status Enable Register 0 122
:ESR0?
0 to 255 Queries Event Status Register 0 122
:ESE1
0 to 255 Sets Event Status Enable Register 1 122
:ESE1?
0 to 255 Queries Event Status Enable Register 1 122
:ESR1?
0 to 255 Queries Event Status Register 1 122
Measurement Mode
:FUNCtion
RV/ RESistance/VOLT-
age
Sets measurement mode 123
:FUNCtion?
RV/ RESistance/VOLT-
age
Queries measurement mode 123
Measurement Range
:RESistance:RANGe
0 to 3100 Sets resistance measurement range 123
:RESistance:RANGe?
3.000E-3 to 3.0000E+3 Queries resistance measurement range 123
:VOLTage:RANGe
-300 to 300 Sets voltage measurement range 123
:VOLTage:RANGe?
6.00000E+0 to
300.000E+0
Queries voltage measurement range 123
Auto Range
:AUTorange
1/ 0/ ON/ OFF Sets the auto range 124
:AUTorange?
ON/ OFF Queries the auto range setting 124
Zero-Adjust
:ADJust:CLEAr
Cancels zero-adjustment 124
:ADJust?
0/ 1 Executes zero-adjustment and queries the result 124
Sampling Rate
:SAMPle:RATE
EXFast/ FAST/MEDi-
um/ SLOW
Sets the sampling rate 124
:SAMPle:RATE?
EXFast/ FAST/MEDi-
um/ SLOW
Queries the sampling rate setting 124
Averaging Function
:CALCulate:AVERage:STATe
1/ 0/ ON/ OFF Sets averaging function execution 125
:CALCulate:AVERage:STATe?
ON/ OFF Queries the averaging function execution setting 125
:CALCulate:AVERage
2 to 16 Sets the no. of samples to average 125
:CALCulate:AVERage?
2 to 16 Queries the no. of samples to average setting 125
Comparator
:CALCulate:LIMit:STATe
1/ 0/ ON/ OFF Sets comparator execution 125
:CALCulate:LIMit:STATe?
ON/OFF Queries the comparator execution setting 125
To Next Page
Loading...
