5.2 Signal Descriptions
80
Instrument Settings
Measurement Fault Output Signal (ERR) Setting
1
(The SHIFT indicator lights up.)
The Menu display appears.
2
Select the ERR Output Selection display.
See "1.4 Menu Display Sequence (SHIFT → ENTER)" (⇒ p.13).
3
Select the type of signal to be output on the Sub Display.
SynC .......... Synchronous output (synchronized with EOM output)
ASynC ....... Asynchronous output (not synchronized with EOM output)
4
Applies settings and returns to the Measurement display.
(Main Display)
(Sub Display)
The current setting blinks.
Setting the EOM Signal
1
(The SHIFT indicator lights up.)
The Menu display appears.
2
Select the EOM-signal setup display.
See "1.4 Menu Display Sequence (SHIFT → ENTER)" (⇒ p.13).
3
Choose the output method for the EOM signal.
HoLd .......... Holds the EOM signal after measurement.
→ Go to Step 5.
PULSE ....... Outputs the specified pulse after measurement.
→ Go to the next step.
4
(When PULSE is selected)
The number representing the pulse width of the EOM signal will start blinking.
Set the pulse width in ms.
5
Applies settings and returns to the Measurement display.
(Main Display)
(Sub Display)
The current setting blinks.
To Next Page
Loading...
