Hioki BT3562-01 - Measurement Value Formats

8.6 Message Reference
150
For the commands that acquire measurement values (:FETCH? and
:READ?), the response formats are as follows.
Measured Resistance
Measured Voltage
*The 300 V range is only available on the Model BT3563(-01).
Relative Value Indication
(same as voltage and resistance)
For positive measurements, the sign position is blank (20H).
When a measurement fault occurs during voltage measurement in the 6 V
range, one more digit is used (for the exponent) for the measured value string
than in other modes.
Unneeded zeroes to the left of the decimal point are replaced by blank space
(20H).
Example :_0001.36E-3 → ____1.36E-3
-0007.51E+0 → -___7.51E+0
("_" indicates blanks space [20H].)
Measurement Value Formats
Measurement range Measured Value ±OF Measurement Fault
3 m
Ω ±.E-3 ±10.0000E+8 +10.0000E+9
30 m
Ω ±.E-3 ±100.000E+7 +100.000E+8
300 m
Ω ±.E-3 ±1000.00E+6 +1000.00E+7
3
Ω ±.E+0 ±10.0000E+8 +10.0000E+9
30
Ω ±.E+0 ±100.000E+7 +100.000E+8
300
Ω ±.E+0 ±1000.00E+6 +1000.00E+7
3000
Ω ±.E+3 ±10.0000E+8 +10.0000E+9
Measurement range Measured Value
±OF Measurement Fault
6 V
±.E+0 ±1.00000E+9 +1.00000E+10
60 V
±.E+0 ±10.0000E+8 +10.0000E+9
300 V
±.E+0 ±100.000E+7 +100.000E+8
Measurement range Measured Value
±OF Measurement Fault
All ranges
±.E+0 ±100.000E+7 +100.000E+8
6 V normal measured value
±.E+0
At 6 V measurement fault
±.E+00