8.6 Message Reference
142
EOM Signal Output Method Settings (software version 1.15 or later)
The following 2 methods can be selected as the EOM signal output method for external I/O. (The EOM sig-
nal is set to ON at end-of-measurement and set to OFF according to the output method that has been set)
• HOLD Holds the EOC signal until mesurement starts by the next trigger signal.
• PULSE Sets EOM=OFF according to the specified pulse width.
Also, the pulse width can be set between 0.001 to 0.099 seconds when PULSE is selected.
EOC Output Mode Setting
Syntax
Command
Query
Response
:SYSTem:EOM:MODE <HOLD/PULSe>
:SYSTem:EOM:MODE?
<HOLD/PULSE>
ON.............. Holds the EOC signal until mesurement starts by the
next trigger signal.
OFF ........... Sets EOM=OFF according to the specified pulse width.
Example
Command
:SYST:EOC:MODE PULS
EOM Pulse Width Setting
Syntax
Command
Query
Response
:SYSTem:EOM:PULSe <Pulse width>
:SYSTem:EOM:PULSe?
<Pulse width> = 0.001 to 0.099 (NR2)[second]
Example
Command
:SYST:EOM:PULS 0.005
Set and query the measurement current pulse output function
Syntax
Command
:SYSTem:CURRent <CONTinuous/PULSe>
Query
:SYSTem:CURRent?
Response <CONTINUOUS/PULSE>
CONTinuous......Measurement current continuous output
PULSe...........Measurement current pulse output
Note
The measurement current is applied continuously when performing continuous
measurement with the internal trigger (:INIT:CONT ON), even if the measurement
current pulse output function is set to generate pulse output.
System Reset
Syntax
Command
:SYSTem:RESet
Description
Command All settings including saved panel settings are returned to factory
defaults. Refer to “Reset Function” for details.
Example
Command
:SYST:RES
Note
• If you want to preserve saved data, use the ∗RST command instead.
• The communications settings are not re-initialized.
To Next Page
Loading...
