Hioki BT3562-01 - Page 51

4.1 Comparator Function
46
11
Press so that the indicated position blinks, and select voltage.
r .............Resistance
u ............Voltage
12
Press so that the indicated position blinks, and select the comparison method for
the comparator (here, REF/%).
HIGH, LOW ..... Compare by upper and lower thresholds (default setting)
REF, %............. Compare by reference value and tolerance
13
Switch to the Ref/% threshold setting display, and specify the thresholds.
14
Applies setting and returns to the Measurement display.
The comparator function is enabled.
To cancel the settings: SHIFT key
u flashing
REF & % flashing
Or
numeric
keypads
For this example,
Reference value: 4.2 V
Tolerance: 0.5%
COMP lit