Hioki DT4282 - Page 25

19
Parts Names and Functions
Measurement terminals
DT4281 DT4282
1 2 3 42 3 4
1
DT4282
Current measurement (A) terminal. The red test lead is connected.
When the rotary switch is set to the current measurement, the shutter
opens.
2
Current measurement (µA, mA) terminal. The red test lead is
connected. When the rotary switch is set to the current measurement,
the shutter opens.
3
Commonly used for each measurement. The black test lead is
connected.
4
Used for voltage measurement, resistance measurement, continuity
check, diode test, temperature measurement, clamp current
measurement
DT4281
, or conductance
DT4282
. Hereafter
referred to as “V terminal”.
The red test lead is connected.
When the rotary switch is set to any of the measurements above, the
shutter of the current measurement terminal is closed.
Be sure to carefully read the precautions in the following references.
See “Precautions during
measurement” (p. 12).
See “Replacing Fuses”
(p. 106).
1
2
3
4
5
6
7
Appx. Ind.
HIOKI DT4281A981-08