IPv6 Settings
The router can configure its IPv6 address the following ways:
Parameter IPv6 WAN-Modes
SLAAC All IP-related settings (address, prefix, routes, DNS server) will be re-
trieved by the neighbor-discovery-protocol through stateless-address-
autoconfiguration.
Static Allows you to define static values. Caution has to be taken to assign
a unique IP address as it would otherwise raise IP conflicts in the
network. You can only configure global addresses. The link-local
address is automatically generated via the MAC address.
DNS Server
When all enabled IP versions are set to Static, you may configure an interface-specific nameserver.
To override the interface-specific nameservers see chapter 6.7.3.
NB1601 58 User Manual for NRSW version 4.8.0.103
To Next Page
Loading...
