Access to the user interfaces
UM Basic Configuration L3P
Release
7.1
12/2011
1.2
Command Line Interface
19
Opening the Command Line Interface
Connect the device to a terminal or to a “COM” port of a PC using
terminal emulation based on VT100, and press any key (see on
page 16 “Opening the system monitor”) or
call up the Command Line Interface via Telnet.
A window for entering the user name appears on the screen.
Up to 5 users can access the Command Line Interface.
Figure 3: Logging in to the Command Line Interface program
Enter a user name. The default setting for the user name is admin .
Press the Enter key.
Enter the password. The default setting for the password is private .
Press the Enter key.
You can change the user name and the password later in the
Command Line Interface.
Please note that these entries are case-sensitive.
The start screen appears.
Copyright (c) 2004-2010 Hirschmann Automation and Control GmbH
All rights reserved
PowerMICE Release L3P-06.0.00
(Build date 2010-09-09 12:13)
System Name: PowerMICE
Mgmt-IP : 10.0.1.105
1.Router-IP: 0.0.0.0
Base-MAC : 00:80:63:51:74:00
System Time: 2010-09-09 13:14:15
User:
To Next Page
Loading...
Need help?
General
