Hirschmann PowerMICE - Monitoring the Device Functions Via the Signal Contact

Operation Diagnosis
220
9.3 Out-of-band Signaling
UM Basic Configuration L3P
Release 7.1 12/2011
9.3.3 Monitoring the Device Functions via the
Signal Contact
 Configuring the operation monitoring
 Displaying the signal contact’s status
The device gives you 3 additional options for displaying the status of the
signal contact:
 LED display on device,
 display in the Web-based interface,
 query in the Command Line Interface.
 Select the Diagnostics:Signal Contact dialog.
 Select "Monitoring correct operation" in the "Mode signal contact"
frame to use the contact for operation monitoring.
 In the "Monitoring correct operation" frame, you select the events
you want to monitor.
 To monitor the temperature, you set the temperature thresholds in
the Basics:System dialog at the end of the system data.
enable Switch to the privileged EXEC mode.
configure
Switch to the Configuration mode.
signal-contact 1 monitor all Includes all the possible events in the operation
monitoring.
signal-contact 1 trap enable Enables a trap to be sent if the status of the
operation monitoring changes.