Hirschmann PowerMICE - Integration into a Control System

EtherNet/IP
UM Basic Configuration L3P
Release 7.1 12/2011
10.1 Integration into a Control System
251
10.1Integration into a Control
System
After installing and connecting the switch, you configure it according to the
“Basic Configuration” user manual. Then:
 Use the Web-based interface in the
Switching:Multicasts:IGMP dialog to check whether the IGMP
Snooping is activated.
 Use the Web-based interface in the
Advanced:Industry Protocols dialog to check whether EtherNet/IP
is activated.
 Use the Web-based interface in the Advanced:Industry Protocols
dialog to download the EDS (EtherNet/IP configuration file) and the icon
to your local computer.
Note: If EtherNet/IP and the router function are switched on at the same time,
malfunctions could occur with EtherNet/IP, for example, in connection with
“RS Who”. Therefore, you should switch off the router function of the device.
 Switch off the router function in the Web-based interface:
Routing:Global dialog.
 Switch off the router function in the Command Line interface:
in the configuration mode (prompt “..(Config)#”) with the command
no ip routing.