Loading/saving settings
UM Basic Configuration L3P
Release
7.1
12/2011
55
3 Loading/saving settings
The device saves settings such as the IP parameters and the port
configuration in the temporary memory. These settings are lost when you
switch off or reboot the device.
The device allows you to do the following:
Load settings from a non-volatile memory into the temporary memory
Save settings from the temporary memory in a non-volatile memory
If you change the current configuration (for example, by switching a port off),
the Web-based interface changes the “load/save” symbol in the navigation
tree from a disk symbol to a yellow triangle. After saving the configuration,
the Web-based interface displays the “load/save” symbol as a disk again.
To Next Page
Loading...
Need help?
General
