Hirschmann PowerMICE User Manual

Operation Diagnosis
UM Basic Configuration L3P
Release 7.1 12/2011
9.3 Out-of-band Signaling
223
Proceed as follows to signal changes to the fan status via a signal contact
and with an alarm message:
 Select the Diagnostics:Signal Contact dialog.
 Select the signal contact you want to use (in the example, signal
contact 1) in the corresponding tab page “Signal contact 1” or
“Signal contact 2”.
 In the “Signal contact mode” frame, select “Function monitoring”.
 In the “Function monitoring” frame, select the fan monitoring.
 Click “Set” to temporarily save the entry in the configuration.
 Select the
Basics: Load/Save dialog.
 In the “Save” frame, select “To Device” for the location and click
“Save” to permanently save the configuration in the active
configuration.
Figure 53: Monitoring the fan with the signal contact and trap

Hirschmann PowerMICE Specifications

General

Brand	Hirschmann
Model	PowerMICE
Category	Network Router
Language	English