Hirschmann PowerMICE - Page 51

Entering the IP Parameters
UM Basic Configuration L3P
Release 7.1 12/2011
2.8 Web-based IP Configuration
51
Figure 16: Network parameters dialog
 Under “Mode”, you enter where the device gets its IP parameters:
 In the BOOTP mode, the configuration is via a BOOTP or DHCP
server on the basis of the MAC address of the device (see page 272
“Setting up a DHCP/BOOTP Server”).
 In the DHCP mode, the configuration is via a DHCP server on the
basis of the MAC address or the name of the device (see page 278
“Setting up a DHCP Server with Option 82”).
 In the “local” mode the net parameters in the device memory are used.
 Enter the parameters on the right according to the selected mode.
 You enter the name applicable to the DHCP protocol in the “Name” line in
the system dialog of the Web-based interface.