To Next Page

To Previous Page

Loading/saving settings

UM Basic Configuration L3P

Release

7.1

12/2011

3.2

Saving settings

Note: After you have successfully saved the configuration on the device, the

device sends an alarm (trap) hmConfigurationSavedTrap together with

the information about the AutoConfiguration Adapter (ACA), if one is

connected. When you change the configuration for the first time after saving

it, the device sends a trap hmConfigurationChangedTrap.

Note: The device allows you to trigger the following events when the

configuration stored on the ACA does not match the configuration on the

device:

 send an alarm (trap) (see on page 213 “Configuring Traps”),

 update the device status (see on page 216 “Configuring the Device

Status”),

 update the status of the signal contacts (see on page 219 “Controlling the

Signal Contact”).

 Skip ACA21 during the boot phase

The device allows you to skip the ACA21 AutoConfiguration Adapter (if

connected) during the boot phase. In this case, the device ignores the

ACA21 during the boot phase. This shortens the boot phase of the device

by 1 to 4 seconds. If you have enabled this function, ACA21-functionality

becomes available as usual after the boot phase. The device simply skips

the ACA21-loading procedures during the boot phase.

enable Switch to Privileged EXEC mode.

configure Switch to Global Configure mode.

#boot skip-aca-on-boot

enable

Skip ACA21 during the boot phase. (Disabled in the as-

delivered state).

#boot skip-aca-on-boot

disable

Include the ACA21 during the boot phase.

#show boot skip-aca-

on-boot

Show whether the "Skip ACA21 during boot phase"

function is enabled.

Hirschmann PowerMICE User Manual

Other manuals for Hirschmann PowerMICE