Hirschmann qSCALE i2 - Operation Group Selection

Operating Mode Selection
© 2016 Hirschmann Automation and Control GmbH · Mobile Machine Control Solutions · www.beldensolutions.com 14/57
qSCALE i2 Cranes (Tool Version 3.0.34) Operators Manual / Issue B / 11-2017 / ac.
2.2.1 Operation Group Selection
The Operation Group Selection screen will allow the user to set the operation mode.
All inputs must correspond to the current set-up status of the crane!

OP MODE
CONFIRM
OPERATION
MODE
SELECTION
Press the operation mode selection screen from the Op-Mode Confirm screen. This will call up the
Operation Mode Selection Screen.
Use the rotary controller to scroll to the operating mode that matches the current crane configura-
tion. Press the key to select. The OP-Mode Confirm screen will be displayed.
The Operation Group Selection screen will be displayed (see Section 2.2.2).
Start SETUP
Procedure
From Configure Op
Mode Screen