Hirschmann qSCALE i2 - Op-Mode Confirm; Adjusting Parts of Line

Operating Mode Selection
© 2016 Hirschmann Automation and Control GmbH · Mobile Machine Control Solutions · www.beldensolutions.com 15/57
qSCALE i2 Cranes (Tool Version 3.0.34) Operators Manual / Issue B / 11-2017 / ac.
2.2.2 Op-Mode Confirm
Pressing the key from the Operating Mode Selection screen (see Section 2.2.1) will select
the displayed operating mode and bring up the Op-Mode Confirm screen.
The system will wait for confirmation or re-entry of the settings (Example):
If a valid operation mode is displayed and the illustration of the crane parts matches the actual
crane configuration, then confirm the entries by pressing the key. This will take the user to the
Main Working Screen (see Section 3.1)
To re-enter the operating mode selection process press the key and follow steps in Section
2.2.1 to select correct operating mode.
The Op-Mode Confirm screen also serves as the menu to access the Setup and Information
screens (see Section 4)
2.2.3 Adjusting Parts of Line
In the Op-Mode Confirm Screen the parts of line (reeving) is able to be adjusted. The current reev-
ing is shown in the icon to the right of the reeving hook.
To adjust, press the key repetitively until correct reeving is shown.
NOTE
The reeving setup is NOT available if man basket or searcher hook operation is selected.
Operation Mode
Confirmation