Introduction
© 2016 Hirschmann Automation and Control GmbH · Mobile Machine Control Solutions · www.beldensolutions.com 4/57
qSCALE i2 Cranes (Tool Version 3.0.34) Operators Manual / Issue B / 11-2017 / ac.
Introduction
This manual is a component of the equipment or systems supplied by Hirschmann Automation and
Control GmbH. Keep this manual in a safe place and ensure that it is available to all users.
The contents of this manual are subject to change. Hirschmann Automation and Control GmbH do
not provide any guarantee for this material, including the associated guarantee regarding marketa-
bility and suitability for certain intended purposes. Hirschmann Automation and Control GmbH ac-
cept no liability for errors in the contents of the manual or for direct or indirect damage in connection
with the provision and use of the manual.
This manual is protected by copyright. All rights reserved. The manual may not be duplicated, re-
produced or translated into another language, either wholly or partly, without the prior written per-
mission of Hirschmann Automation and Control GmbH.
The rendition of common names, trade names, trademarks etc. in this documentation should not be
construed to mean that such names, even without special identification, are free in the sense of
trademark and trademark protection legislation and hence usable by anyone.
This device/system is intended exclusively for the tasks described in this manual. Any other use
shall be construed as being inappropriate. The manufacturer accepts no liability for damage caused
by inappropriate or impermissible use. This device / system may only be used if it is in perfect tech-
nical condition.
Only appropriately qualified personnel may work with this device / system, i.e. persons:
who are familiar with the operation or installation and commissioning
who know the current regulations for the prevention of accidents
To Next Page
Loading...