Hitachi CP100NX User Manual

Step Touchscreen operation Screen displays and notes
18 Press the ω
2
T display area
and enter the desired value.

Enter the desired value and press the [Enter] button.
19 The [Enter] button is
replaced by the [OK] button.
Check the entered value and
press the [OK] button.
 The TIME (run time) computed from the SPEED value and
the
ω
2
T value set in steps 17 and 18 is displayed in the TIME
setting value field.
 To register step-mode operations, press the [Next Step]
button and enter the next run parameter.
For details, refer to Section 3-3-1-3 "Step-Mode Operation
Procedures."
1) Pressing the [Register] button when no numeric value is
entered in the SPEED, TIME, TEMP, ACCEL or DECEL
field, will generate an error and the field where the error
occurred turns red. An inappropriate setting value will also
cause the field with the error to be displayed in red.
Example: When SPEED and TIME are not set
2) Be sure to set the SPEED, TIME, TEMP, ACCEL and DECEL
run parameters.
(Program registration and operation can be
performed without entering RCFmax, RCFavg and ω
2
T.)
3) RCFmax and RCFavg cannot be registered without installing
a rotor.
4) ω
2
T cannot be registered without setting SPEED.
NOTE
3-3-1-1 Program Registration Procedures
●
The run parameter
entry/display screen
reappears.
[Register] button
[Next Step] button
ω
2
T display
(Left area) Mantissa
(Right area) Exponent
●
The ω
2
T setting
screen appears.
Example)
ω
2
T：1.98×10
12
3-30

Hitachi CP100NX Specifications

General

Brand	Hitachi
Model	CP100NX
Category	Laboratory Equipment
Language	English