Hitachi CP100NX User Manual

Step Touchscreen operation Screen displays and notes
5 b-1) To confirm registered
data, press the [Folder]
button you want to verify,
and press the [MENU]
button after the folder
turns blue.
b-2) Press the [Reference]
button in the [MENU]
field.
Press the [Select] button
if the target program
appears.
 If the progr
am that appeared is not the program you wanted,
press the [X] button to return to the Program list screen and
check a different folder.
6 Do not change the run
parameters after calling the
program.
 Operate the centrifuge according to the instructions in
Section 3-2-5 "Operation Procedures."
 Reentering (changing) the run parameters (for example,
SPEED, TIME, etc.) after calling a program will cancel a
called program.
To combine programmed operation and RTC operation (refer to Section 3-3-4 RTC (Real
Time Control) operation"), set RTC after calling the program. When a program includes
step-mode operation, the run time of all steps must be calculated to compute RTC start time
since the program cannot be called once RTC is set.
●
The MENU box appears
in the Program list
screen.
[Select] button
3-3-1-2 Programmed Operation Procedures
[Reference] button
MENU box
●
The Check registered
parameter screen
appears.
NOTE
3-40

Hitachi CP100NX Specifications

General

Brand	Hitachi
Model	CP100NX
Category	Laboratory Equipment
Language	English