Hitachi DIGITAL 8 VM-D965LE - Page 109

rp
SSS,
1.3.2 Mechanical Block Self-Diagnostic Function (B Mode)
Caution: Complete the A mode before engaging the B mode.
(1) Setting Procedure
1) | Connect (attach) a power supply (battery).
2) Press the EJECT switch to set to the eject state.
3)
Press
the
"Hi-8
MP"
switch
on
the
trouble
sensor
and
the
DATE
button
and
hold
them,
then
set
the
CAM/OFF/VIDEO
switch
to
"VIDEO"
(Hoid
this
state
for
a
few
seconds.)
[Within
3
seconds].
4) Close the cassette lid.
5) | The procedure ends in the eject state.
Note: Do not close the cassette lid.
Supply reel disk
Idier plate
Cassette holder
switch
Hi-8 MP switch
Sub chassis
Fig.1-3 Hi-8 MP Switch Position tl
< Results of self-diagnosis >
E6.
D
<Vx.xx>
200x/xx/xx
*
The
defective
items
flash.
UNL. ¢ The shaded items are the tape detection switches
RST and cassette holder switch which flash when they
are not pressed.
* See Table 1-3 for the results of diagnosis.
Cautions:
¢ Do not press any buttons other than those specified
during self-diagnosis; otherwise, it may cause a
malfunction.
* The indications in dotted lines are not covered by
the self-diagnostic functions.
* It is normal for the diagnostic procedure to end in
the eject state. Do not close the cassette lid
thereafter.
[To release]
* Set the CAM/OFF/VIDEO switch to "OFF".