2 Unit installation
RCIM - 4-way cassette (compact)
SMGB0099 rev.0 - 12/2016
34
Electrical connection of the air panel
! CAUTION
• Perform securely the electrical wiring work. If the electrical work is not completed, heat generation at the connection, a re or an
electric shock may occur.
• Make sure that the wires are securely xed in order not to apply an external force to the terminal connections of the wirings. If xing
is not completed, heat generation or a re will occur.
1 The following connectors are used in the air panel. Remove the tape xing the wiring connectors on the air panel and
pull out them as shown in the gure below. Connect them with the wiring connectors to CN17 in the electrical box as
the following gure.
? NOTE
Before the electrical wiring work, turn OFF the power source. If the connectors are connected without turning OFF the power source,
the auto swing louver can not activate.
ON
12
ON
12
CN17
Air panel
PCB
Cable for auto
swing motor
Connector
(CN17)
Earth
screw
Electrical box
Indoor unit
Wire clamp
Control cable
Remote control switch cable
Power source cable
2 After completing the wiring connection of the air panel, attach the air inlet grille. Perform the attaching work in the
reverse procedure of removing. Hook the swivel of the supporting string at Ⓐ to the hole at the air panel. The air inlet
grille can be attached from any 4 directions by rotating it. When multiple indoor units are installed or requested from a
user, the air intake grille direction can be selected freely.
Supporting string
Hole at air panel
Ⓐ Part
To Next Page
Loading...
Need help?
General
