Hitachi VM-C52E - Using the Audio Dubbing Feature

USING THE AUDIO DUBBING FEATURE
The audio dubbing feature lets you record new audio (sound) on a previous recorded tape without erasing the original
video (picture).
When you audio dub a tape, the previous audio is erased and replaced with new sound.
To “EURO’
Jack
Audio/Video Output Cable
NOTES: © Sound from the built-in microphone and external microphone can be dubbed.
* Do not connect an external microphone when dubbing audio from the built-in microphone. Connecting
an external microphone switches off the built-in microphone automatically.
e \t is not necessary to connect the PAUSE plug (black).
1. Insert a recorded tape. a
Be sure that the record safety tab is not missing.
. Slide the mode shifter upward to turn on VTR power.
. Play the tape and press PAUSE button where you
want to dub audio.
e The camera/recorder enters the still play mode.
4. Slide AUDIO DUB Switch
e “A.DUB” appears in the viewfinder.
5. Press PAUSE button to start audio dubbing.
6. Press STOP button to stop audio dubbing.
wh
ai
NOTE: {f counter memory ‘’M”’ appears in the view-
finder, the tape stops automatically at the reading of
“0000” and audio dubbing stops. STOP Button
A.DUB Switch
PAUSE Button
PLAY Button
Mode Shifter
27