Hitachi VM-C52E - Video Channel Setting

Example 3: If your TV is a regular TV,
Aerial Camera/Recorder
To Aerial terminal
To “IN FROM ANT”
To “OUT TO TV”
Aerial
Cable
RF
Converter
Unit
1.
Remove
the
antenna
cable
from
your
TV
set.
Con-
5.
Turn
on
the
TV
and
select
an
unused
channel
nect
this
cable
to
“IN
FROM
ANT”
on
the
RF
con-
(CH37).
Refer
to
‘VIDEO
CHANNEL
SETTING’
verter
unit.
below.
2.
Connect
the
Aerial
cable
to
"OUT
TO
TV”
on
the
RF
6.
Perform
same
procedures
in
steps
4
through
7
of
converter
unit.
“Example
2”
on
page
25.
3. Connect the other end to aerial terminal on your TV.
4. Connect the connector cable from RF converter unit
to “AV OUT” on the camera/recorder.
NOTE: If you want to watch a TV programme with camera/recorder connected as illustrated, slide the mode
shifter of the camera/recorder to turn off the power, or disconnect the connector cable of RF converter unit
from ‘AV OUT” jack on the camera/recorder.
VIDEO CHANNEL SETTING
When viewing the picture played back by the camera/recorder on your TV, change over the |/G select switch of
the RF converter unit matching your TV as well as to select the video channel on the TV.
1. Connect TV, RF converter unit and camera/ 6. Press PLAY button of camera/recorder.
recorder. (See above) Now playback picture appears on your TV.
2. Set I/G select switch on RF converter unit as If the playback picture is not clear or channel 37 is
follows. used for broadcasting in your area, adjust the RF out-
put control of RF converter unit using a small screw-
Colour TV broadcast system | Position of I/G driver and readjust your TV until the playback picture
in your country Select Switch is clearly observed.
PAL (System |) |
1/G Select Switch
PAL (System B & G) G
RF Output Control
3. Turn on TV and select an unused channel (CH37). (In
some cases this may be marked A/V.)
4. Insert the recorded tape to camera/recorder.
5. Slide the mode shifter to turn on the VTR power.
26