HITEC Flash 8 - Page 19

34 35
Model Select Menu cont.
1. Create a new model: When you create a new model, you
are also prompted to do other setup items. To avoid repetitive
information it is recommended that you read the quick start
guides in order to understand what other steps are required
when creating a new model. The “New” option is only available
if the last model in the list is selected.
2. Select an existing model:
b. Highlight “SELECT” and press
the jog dial.
c. When asked if you would like to
change the model, highlight
“YES” and press the jog dial.
3. Copy one model’s data into another memory slot:
a. If you haven’t already done so, create a new model by following the ACRO or HELI Quick Start
instructions.
c. Scroll to “COPY” and press
the jog dial to activate the
destination menu.
d. Scroll to select the model
memory slot where you would
like to place the data. Press the
jog dial to conrm your selec
tion.
e. When prompted to conrm that you want to copy, select “YES”
and press the jog dial to conrm your selection.
b. In the model select menu,
highlight the model you wish
to copy and press the jog dial.
a. Use the jog dial to scroll
through the list of models.
When you have highlighted
the model you want to
work with, press the jog dial
to conrm your selection.
Model Select Menu
4. Reset the active model memory slot to factory default settings:
b. Scroll to “RESET” and press
the jog dial.
a. Select the model you wish
to reset.
c. When prompted that you want to reset the model, select yes and
press the jog dial to conrm your entry. You have now cleared all
of the programming for the model. The only settings that will
remain are the model name, receiver type and wing and tail types.
5. Delete a model memory:
a. In the model select menu, highlight the
model you wish to delete and press the jog dial.
b. Scroll to
“DELETE”
and press
the jog dial.
c. When prompted
that you want to
delete the model,
select yes and
press the jog
dial to conrm
your entry.
6. Rename a model:
a. In the model select menu, highlight the model you wish to rename. Press the jog dial to conrm your
selection.
b. Scroll to RENAME and press
the jog dial to enter the nam
ing screen.
d. Use the jog dial to scroll
through the characters and
press it once to select the char
acter.
e. Repeat steps c and d until you have renamed the model.
f. Press the back button to return to the model select menu.
c. In the eld displaying the
current model name, scroll to
the character you want to
change and press the jog dial
to activate it. The cursor will
blink under the active character.
You can only reset the active model.
You cannot delete the active model.
Note
Note