HITEC Flash 8 User Manual

78 79
15. Scroll to the “S/W” eld and press the jog dial twice to
activate the menu.
b. If you choose a switch:
- The switch position menu will appear. Scroll to highlight
the switch position that you will use to enable the mix.
Press the jog dial to conrm your selection.
16. Scroll to select a switch to activate the camber mix. Press the jog dial to conrm your selection.
a. If you choose the “NULL” option, the mix will remain inactive at all times for this model.
17. Set up accordance with Flight Condition
- Scroll to select “ON” and press the jog dial to conrm your
selection. If you toggle the selected switch, the eld in the
top right corner of the screen will indicate when the mix
is active.
- The upper right eld of the menu displays which ight
condition is currently active and will be programmed.
- Scroll to the Flight Condition eld and press the jog dial to
activate the menu.
- Choose the desired ight condition and press the jog dial
to conrm your selection.
Camber Mix (GLID Only) cont.
- Repeat steps 4-14 to dene the settings for each ight condition.
18. Press the back button to return to the model function menu.
You may also select a ight condition in this menu by activating the desired ight condition.
To disable the elevator-to-camber mix:
1. Scroll to highlight the “MIX” eld in the camber mix menu and
press the jog dial to activate the menu.
2. Select “INH” (inhibit) and press the jog dial to conrm your
selection.
3. Press the back button to return to the model function menu.
TipTip
Tip
Flap Con
To congure ap control:
1. From the model menu, rotate the jog dial to highlight “FLAP
CON” and press the jog dial once to enter the activation menu.
2. Press the jog dial again to activate the menu.
3. Rotate the jog dial to select “ACT” (activate), then press the jog
dial to conrm your selection and activate the ap control
menu.
4. Highlight the “FLAP” row of the value table and press the jog
dial to activate the menu.
5. Scroll to highlight L/U” (Left/Up) “R/D” (Right/Down) eld and
press to enter the menu.
6. Scroll the jog dial to increase(clockwise) or decrease
(counter-clockwise) the maximum & minimum servo endpoint
for “FLAP”. Please be careful not to brake the surface and the
linkage while adjusting the desired movement angle.
Press the jog dial to conrm the input.
7. For left roll command, highlight “L/U” (Left/Up) eld and
press the jog to enter the menu.
8. Scroll the jog dial to increase (clockwise) or decrease
(counter-clockwise) the minimum servo endpoint for “FLAP”.
This is the minimum angle when the ap is folded.
Press the jog dial to conrm the input.
9. For right roll command, highlight “R/D” (Right/Down) eld and
press the jog to enter the menu.
10. Scroll the jog dial to increase (clockwise) or decrease
(counter-clockwise) the maximum servo endpoint for “FLAP”.
This is the maximum angle when the ap is opened.
Press the jog dial to conrm the input.
Flap Control is used to mix elevator control with ap movements. This is an eective way of avoiding pitch
changes to the aircraft when aps are deployed.

HITEC Flash 8 Specifications

General

Interface	-
Input type	Press buttons
Product color	Black, Silver
Built-in display	Yes
Maximum range	- m
Frequency band	2.4 GHz
Channels quantity	8 channels

Weight and Dimensions

Weight	- g