HITEC Flash 8 User Manual

46 47
15. Scroll to highlight “FLIGHT CONDITION” and press the jog dial
to activate the menu.
16. Scroll to select “ON” or “OFF”. When the ight condition
warning is turned on, the radio will warn you if any
programmed ight conditions are active when the unit is
powered on. Press the jog dial to conrm your selection.
17. scroll to select “FEEDBACK”, then press the jog dial to enter
the menu.
18. select the FEEDBACK type by scrolling the jog dial,
and press the jog dial to conrm the function.
This function provides beep sound and vibration for
diverse warning alarm settings.
19. press Back button twice to return back to system menu.
Management Menu cont.
INFO
The Info screen displays the current rmware information for the
radio.
1. From the system menu, highlight “INFO” and press the jog dial
once to see the information.
2. Press the back button to return to the system menu.
The Model Function menu contains options that relate to all model types (common) as well as options
which are specic to xed wing models (ACRO/GLID) or helicopters (HELI). This section illustrates the
common model function options. The features specic to xed wing or helicopter model types are
covered in Section Five and Section Six respectively.
Common Model Programming Menu
If you have not already programmed a model with the preceding quick start guide, we
encourage you to do so before tackling the model programming section of the manual.
From the Model Function menu, you can program the following common functions:
REVERSE: Specify the direction that a servo will travel with a given control input.
SUB TRIM: Fine-tune the neutral point of a servo.
D/R & EXP: Specify Dual-Rate and Exponential settings for control surface servos.
EPA: Specify the servo travel limits for channels 1-8.
S.Speed: Specify the transit speed for servos on channels 1-8.
PROG.MIX: Congure up to three user-programmable mixes.
F.COND : Congure specic control settings for dierent phase of ight.
TIMER: Congure two user-programmable timers.
MONITOR: Observe graphic feedback to control inputs.
Working with the Common Model Function Menus
1. Turn on the transmitter. When prompted with the “ready to
transmit?” message, highlight “NO” and press the jog dial.
2. To access the model function menu, press and hold the jog
dial.
3. The menu options shown reect the parameters dened for
the active model in the model type menu (Model Type, Wing,
Tail, Swash). Common model items are integrated with the
xed-wing and helicopter-specic options in the menu.
TipTip
Tip

HITEC Flash 8 Specifications

General

Interface	-
Input type	Press buttons
Product color	Black, Silver
Built-in display	Yes
Maximum range	- m
Frequency band	2.4 GHz
Channels quantity	8 channels

Weight and Dimensions

Weight	- g