HITEC Flash 8 - Reverse; Specifying Servo Rotation Direction; Sub Trim; Fine-Tuning Servo Neutral Point

92 93
F. Cond cont.
The following features support ight condition programming in HELI mode:
Gyro
Revolution Mix
Swash > Throttle Mix
Throttle Curve
Pitch Curve
Goveronr
1. From the model menu, rotate the jog dial to highlight
“F.COND” and press the jog dial once to enter the ight
conditions menu.
2. Scroll to the ight condition to be congured and press the
jog dial to conrm your selection.
3. Press the jog dial again to activate the switch selection menu
(not applicable in “Normal” ight condition).
4. Scroll to select the switch that you will use to activate this
ight condition and press the jog dial to conrm your
selection.
a. If “NULL” is selected, the ight condition will be inactive.
b. If you selected a switch, the switch position menu will
appear.
- Scroll to highlight the switch position that you will use to
enable the ight condition. Press the jog dial to conrm
your selection.
- Scroll to select “ON” and press the jog dial to conrm your
selection. If you toggle the selected switch, the eld in the
top right corner of the screen will indicate which ight
condition is active.
- Press the back button twice to return to the ight
conditions menu.
F. Cond cont.
Thro Cut
Throttle Cut is a vital safety feature when ying glow or gas-powered models. This feature will command
the throttle servo to a preprogrammed position with a switch movement. You may choose to set the
servo to bring the engine to low-idle, or even shut it down.
To congure throttle cut:
If the more than one ight condition is concurrently enabled, the condition with the highest
number (per the table shown above) will be active. The eld just below the model icon on the
Home screen indicates the active ight condition.
5. Scroll to highlight the “SPEED” eld and press the jog dial to
activate the menu.
6. Scroll to dene the amount of time (0.0 to 10.0 seconds) to
transition the settings when this ight condition is enabled.
Press the jog dial to conrm your selection. This feature can
be utilized to prevent sudden control surface movements
when switching between ight conditions.
7. Press the back button to return to the ight conditions menu and repeat steps 2-6 to
dene further ight conditions.
8. Press the back button twice to return to the model function menu.
1. From the model menu, rotate the jog dial to highlight “THRO
CUT” and press the jog dial once to enter the activation menu.
2. Press the jog dial again to activate the menu.
3. Rotate the jog dial to select ACT (activate), then press the jog
dial to conrm your selection and activate the throttle cut
menu.
Note