HITEC Flash 8 - Channel Selection Menu; Assigning Channels to Functions and Controls

76 77
- Scroll to select “ON” and press the jog dial to conrm your
selection. If you toggle the selected switch, the eld in the
top right corner of the screen will indicate when the mix is
active.
27. Set up accordance with Flight Condition
-The upper right eld of the menu displays which ight
condition is currently active and will be programmed.
- Scroll to the Flight Condition eld and press the jog dial to
activate the menu.
- Choose the desired ight condition and press the jog dial to
conrm your selection.
- Repeat steps 4-21 to dene the settings for each ight condition.
Elev>Camb cont.
28. Press the back button to return to the model function menu.
To disable the elevator-to-camber mix:
1. Scroll to highlight the “MIX” eld in the elevator-camber mix
menu and press the jog dial to activate the menu.
2. Select “INH” (inhibit) and press the jog dial to conrm your
selection.
3. Press the back button to return to the model function menu.
To congure the camber mix:
1. From the Model menu, rotate the jog dial to highlight “Camber
Mix” and press the jog dial once to enter the activation menu.
Camber Mix (GLID Only)
The Camber Mix feature allows you to dene the camber of the wing airfoil by raising or lowering the
wing control surfaces in unison. You may also adjust the elevator neutral position in each setting to
maintain proper pitch trim.
You may also select a ight condition in this menu by activating the desired ight condition.
TipTip
Tip
Camber Mix (GLID Only) cont.
2. Press the jog dial again to activate the menu.
3. Rotate the jog dial to select “ACT” (activate), then press the
jog dial to conrm your selection and activate the camber mix
menu.
4. Scroll to highlight the “AILE” eld and press the jog dial to
activate the menu.
5. Rotate the jog dial to input the desired travel for the “AILE”
servo when camber is active. Press the jog dial to conform
your input.
6. If the model has a second aileron servo, repeat step 5 in the
“AIL2” eld.
7. Scroll to highlight the “ELEV” eld and press the jog dial to
activate the menu.
8. Rotate the jog dial to input the desired travel for the “ELEV”
servo when camber is active. Press the jog dial to conform
your input.
9. If the model has a second elevator servo, repeat step 8 in the
“ELE2” eld.
10. Scroll to highlight the “FLAP” eld and press the jog dial to
activate the menu.
11. Rotate the jog dial to input the desired travel for the “FLAP”
servo when camber is active. Press the jog dial to conform
your input.
12. If the model has a second ap servo, repeat step 11 in the
“FLP2” eld.
13. Scroll to highlight the “SPEED” eld and press the jog dial to
activate the menu.
14. Scroll to dene the amount of time (0.0 to 10.0 seconds) for
the camber settings to fully deploy. Press the jog dial to
conrm your selection.