HITEC Flash 8 User Manual

68 69
Aircraft with a V-tail conguration can use this function to specify the limits of travel for both tail control
surface servos.
V-Tail Mix
2. Scroll to the top “ELEV” eld and press the jog dial to activate
the menu.
1. From the model menu, rotate the jog dial to highlight “V.Tail
Mix” and press the jog dial once to enter the V-tail mix menu.
5. Scroll to highlight the “R/D” (right/down) eld and press the
jog dial to activate the menu.
6. Rotate the jog dial to increase (clockwise) or decrease
(counter-clockwise) the desired servo endpoint when a pitch
down command is given. Press the jog dial to conrm your
input.
3. Scroll to highlight the “L/U” (left/up) eld and press the jog
dial to activate the menu.
4. Rotate the jog dial to increase (clockwise) or decrease
(counter-clockwise) the desired endpoint for the servo
attached to the “ELEV” receiver slot. This value regards the
servo travel when a pitch up command is given. Press the jog
dial to conrm your input.
9. Scroll to highlight the “L/U” (left/up) eld and press the jog
dial to activate the menu.
10. Rotate the jog dial to increase (clockwise) or decrease
(counter-clockwise) the desired endpoint for the servo
attached to the “RUDD” receiver slot. This value regards the
servo travel when a pitch up command is given. Press the jog
dial to conrm your input.
7. Press the back button the return to the V-tail menu.
8. Scroll to the top “RUDD” eld and press the jog dial to activate
the menu.
Ailevator
The Ailevator feature allows the conguration of a two-servo or “split” elevator setup. It also features an
“aileron to split elevator” mix which allows the elevators to provide roll control. This feature, also called
“tailerons”, is commonly used on jet models.
1. From the model menu, rotate the jog dial to highlight
“AILEVATOR” and press the jog dial once to enter the ailevator
mix menu.
2. Scroll to the top “ELEV” eld and press the jog dial to activate
the menu.
3. Scroll to highlight the “L/U” (left/up) eld and press the jog dial
to activate the menu.
4. Rotate the jog dial to increase (clockwise) or decrease
(counter-clockwise) the desired endpoint for the servo
attached to the “ELEV” receiver slot. This value regards the
servo travel when a left roll command is given. Press the jog
dial to conrm your input.
11. Scroll to highlight the “R/D” (right/down) eld and press the
jog dial to activate the menu.
12. Rotate the jog dial to increase (clockwise) or decrease
(counter-clockwise) the desired servo endpoint when a
pitch down command is given. Press the jog dial to conrm
your input.
13. Press the back button t o return to the V-tail Mix menu.
14. Repeat steps 2-13 using the lower “ELEV” and “RUDD” elds to set servo endpoints when yaw (rudder)
commands are given.
15. If elevator and/or rudder functions operate in the incorrect
direction, highlight the direction eld (“nor”) under the
reversed function and press the jog dial to activate the menu.
16. Scroll to select “rev” and press the jog dial to conrm your
selection. Verify that the control surfaces now move in the
correct direction.
17. Push the back button twice to return to the model function menu.
V-Tail Mix cont.

HITEC Flash 8 Specifications

General

Interface	-
Input type	Press buttons
Product color	Black, Silver
Built-in display	Yes
Maximum range	- m
Frequency band	2.4 GHz
Channels quantity	8 channels

Weight and Dimensions

Weight	- g