〈〉〈〉
107
OPERATION
Over-rev Limiter Anode
Painting or coating the anode will
lead to rust and corrosion damage
to the outboard motor.
ANODE
(stern bracket)
WATER
SEPARATOR
ANODE (each side)
When the water separator buzzer
sounds:
Check the water separator for
water contamination. If water is
accumulated, clean them (see page
).
This outboard motor is equipped with
an engine over-rev limiter which
activates when the engine speed
increases excessively. The over-rev
limiter can be activated while
cruising, tilting up the motor, or
when ventilation occurs during a
sharp turn.
When the over-rev limiter is
activated:
Reduce the throttle opening
immediately and check the trim
angle.
If the trim angle is correct but the
over-rev limiter stays activated,
stop the engine, check the
condition of the outboard motor,
check to see if the correct propeller
is installed and check it for
damage.
Correct or service as necessary, by
contac ting your authorized Honda
outboard motor dealer.
There are also 2 small sacrificial
anodes in the water passages of the
engine block.
The anode is a sacrificial material
which helps to protect the outboard
motor from corrosion.
1.
1.
127
2.
To Next Page
Loading...
