Honeywell ESSER Fire Alarm Control Panel Compact User Manual

Fire Alarm Control Panel Compact
42 FB 798238.GB0 / 10.14
8.2 Deactivation of FIP / FOP activation
This function allows the deactivation of an FIP / FOP (Fire Brigade Indicating Panel / Fire Brigade Operating
Panel). These devices are connected to the RS485 interface of the fire alarm control panel. Devices connected
to this interface are not activated when the RS485 interface is switched off (i.e. configured as ‘unused’).
4
GHI
3
1 mainboard
- slot 1 [empty]
- slot 2 [empty]
4 expansion module [empty]
configuration
3
1
3
1 IN-4 : 3.3k / 680 Ohm
2 zones
- esserbus
4 RS485 : EDP
- RS232 : not used
3
3
1 IN-4 : open/closed
2 zones
- esserbus
4 RS485 : FIP/FOP
- RS232 : not used
mainboard
3
3
1 zones
2 control zones
- detector/transponder
4 configuration
5 settings
6 verify and save
configuration
3
mainboard
4
GHI
33
mainboard
1 IN-4 : 3.3k / 680 Ohm
2 zones
- esserbus
- RS485 : not used
- RS232 : not used
Fig. 63: Switch-off FIP/FOP
Select configuration
Select mainboard
Use the >down< cursor key
Select RS485 and set to >not used< by pressing the
4GHI
key
several times (toggle function) until ‘not used’ is displayed.
 Save entry
ESC  Cancel entry or exit sub-menu

Honeywell ESSER Fire Alarm Control Panel Compact Specifications

General

Brand	Honeywell
Model	ESSER Fire Alarm Control Panel Compact
Category	Fire Alarms
Language	English