Honeywell ESSER Fire Alarm Control Panel Compact - Mainboard and Interface Settings; Mainboard Configuration Details; RS485 and RS232 Interface Settings

Fire Alarm Control Panel Compact
20 FB 798238.GB0 / 10.14
5.5 Configuration
The interfaces and the inputs and outputs of the mainboard are configured in this menu. Only the EDP protocol
is implemented for the RS485 interface.
4GHI
3
1 mainboard
2 slot 1
3 slot 2
4 expansion module
configuration
3
1
3
3
mainboard 1/2
3
1 zones
2 control zones
- detector/transponder
4 configuration
5 settings
6 verify and save
configuration
3
mainboard 2/2
1 Out-1 : monitored
2 Out-2 : monitored
3 Out-3 : EOL-O
4 Out-4 : EOL-O
IN-1 : open / closed
IN-2 : open/ closed
7 IN-3 : 3.3k / 680 Ohm
1 IN-4 : open / closed
- zones
- esserbus
4 RS485 : unused
5 RS232 : unused
Fig. 31: > Configuration< menu screens
RS485  toggle between unused, FIP / FOP and WINMAG
The WINMAG setting serves the connection to a higher-level
Management Systems with the EDP protocol.
RS232  for future use