Fire Alarm Control Panel Compact
FB 798238.GB0 / 10.14 5
2.1 Installation of the programming software tools 8000
When installing the programming software tools 8000 of version V1.16 or higher, it is also necessary to update
the USB drivers for the PC interface. This update takes place automatically along with the installation.
Fig. 1: Installation of the programming software tools 8000
Fig. 2: Installation of the required USB drivers
USB drivers
If the USB drivers have accidentally been deleted or damaged on the service PC, they can be
installed later as well, after installation of the programming software.
The USB drivers are located in the directory >Firmware | USB> on the installation CD for the
programming software tools 8000.
To Next Page
Loading...
Need help?
General
