Configuring Event Settings | 109
800-21090V2 - A - 03/2016
5. Click Apply to save your settings.
Configuring Network Event Settings
To configure network event settings
1. Go to Main Menu > SETTING > EVENT > ABNORMALITY > Network.
Figure 8-9 Network Abnormality Configuration Tab
2. On the Network tab, in the Event Type box, select the event type for which you want to
configure settings: Net Disconnection, IP Conflict, MAC Conflict.
3. Select the Enable check box to enable network error detection.
4. Select the actions that you want the system to initiate when the selected event occurs:
5. Click Apply to save your settings.
•Send Email
Select the check box to enable the system to send an email notification.
To set up Email settings, see
Configuring Email Settings
on page 93.
• Buzzer
Select the check box to activate a buzzer noise at the NVR.
•Alarm Out
Select the check box to activate the selected alarm output(s) (
1
or
2
). In
the
Latch
box, specify the amount of time (1–300 s) to delay the alarm
output signal after the network event is triggered.
•Show Message
Select the check box to enable a pop-up message on your local host PC.
•Send Email
Select the check box to enable the system to send an email notification.
To set up Email settings, see
Configuring Email Settings
on page 93.
• Buzzer
Select the check box to activate a buzzer noise at the NVR.
To Next Page
Loading...
Need help?
General
