www.honeywell.com/security
90 | Performance Series Full PoE Network Video Recorder User Guide
Configuring Advanced Network Settings
This section describes how to configure PPPoE, DDNS, SMTP, FTP, UPnP, SNMP, and
multicast settings.
Configuring PPPoE Settings
To enable a Point-to-Point Protocol over Ethernet (PPPoE) network connection
1. In the SETTING field in the Main Menu, go to NETWORK > PPPOE.
Figure 7-5 Network PPPoE Settings Window
2. On the PPPOE page, select the Enable check box to enable a PPPoE network
connection.
3. In the Username and Password boxes, enter the user name and password provided by
your Internet service provider for PPPoE access.
4. Click Apply to save your settings.
5. If you want to save your settings and exit the SETTING menu, click OK.
6. Restart the NVR for the new network connection settings to take effect.
The NVR’s new IP address appears on the PPPOE page. Use this address when
accessing the NVR remotely.
To Next Page
Loading...
Need help?
General
