Fire Alarm Control Panel LT-32 / LT-159
M-168.1-SERIE-LT-EN / 08.2022 41
3. To define a Point, press on the icon , then press at the right side of the device number (e.g., S001) below the icon and type the name of the device. It is
possible to insert up to 20 characters. Press the "enter" key to save and confirm the zone description. Press the back arrow to go back to the previous screen.
4. Press on the zone number to change the Zone to which the device is linked.
This icon indicates whether the device is a module (M) or a sensor (S).
This icon indicates the zone to which the sensor is linked.
To Next Page
Loading...
