NFS2-640/E Programming Manual — P/N 52742:L2 7/17/14 117
Type Codes for Output Devices Type Codes
GENERAL
PEND
N Control Module, an XPC-8 circuit, or an XP5-C (in NAC mode) that
will activate upon receipt of an alarm and/or trouble condition, and
remain in the ON state until all events have been
ACKNOWLEDGED.
TROUBLE
PEND
N Control Module, an XPC-8 circuit, or an XP5-C (in NAC mode) that
will activate upon receipt of a trouble condition, and remain in the
ON state until all troubles have been ACKNOWLEDGED. It is
programmed as “switch inhibit”.
Table F.4 NAC Type Codes
To Next Page
Loading...
