118 NFS2-640/E Programming Manual — P/N 52742:L2 7/17/14
Appendix G: Region Settings
The REGION panel programming selection provides a setting for China. (Refer to “The Utility
Program” on page 48.) This selection activates the following features:
• POM-8A support
• Active output events displayed. A counter is displayed for active outputs.
• Municipal communication panel settings
• New special function zone for alarm verification
• Prealarm automatically cleared after five minutes
• Co-op detectors alarm functions
• Dual alarm window
• Points in trouble will not activate
• Ten minute limit for DEL and SDEL delay functions
• Disable events do not light LED or trip the trouble relay
• no system trouble generated upon entering program mode
• Low AC operation of FACP
• Power supply troubles
To Next Page
Loading...
Need help?
General
